The L208 Lamp Control Module is member of INNCOM's Integrated Room Automation System (IRAS). It converts any standard lamp into a remotely controlled lamp. The L208 module plugs directly into any 110 VAC outlet. The lamp power cord is then plugged into the module and the plastic cover is installed.
Remote control is effected using infrared (IR) commands from any INNCOM IR compatible device, such as the IR3035 Control Console, the e4 Digital Thermostat, and others. For example, the lamp may be turned on or off using the keys on the IR3035 Controller, or it could automatically be turned on and adjusted through commands from the e4 Digital Thermostat upon guest check-in -- or automatically turned off upon guest check-out.
The L208 can be used as a gateway for wireless communications for Central Electronic Locks (CELS) and INNCOM™'s Central Interface Network (CINET). When used with a bridge device, the L208 is an IR transceiver that enables the IR3035 table-top controller to be a wireless device.
The L208 consists of two parts: (1) a remotely located switch for the lamp, and (2) a Power Supply (PS) with IR Receiver, that is typically mounted or placed in an out-of-sight location. The lamp cord is simply plugged into the L208 which is powered from a standard wall outlet. The remote switch is then connected to the L208 with a standard RJ9 phone-type plug. For local control, when the switch is pressed and released, the lamp is toggled on or off.
For remote infrared operation, the same functionality is achieved by using IR commands from any compatible INNCOM device. For example, the lamp may be turned on or off using the keys on the IR3035 Controller, or it could automatically be turned on and adjusted through commands from the e4 Digital Thermostat upon guest check-in or automatically turned off upon guest check-out.
The L208 Lamp Control Module is typically used as device to control a lamp wirelessly from another IR equipped device. It can be effectively used in Master Light Switch configurations to control lamps in guestrooms from a single location or at the individual lamp. It can also be connected to an IR3056 to provide IR connectivity while providing remote wireless control to a bedside lamp.
- Creates remote control for table or floor lamps
- Easy installation
- IR address can be changed remotely
- Repeater capability for IR commands to other IR devices
- Multiple switch point control
- Standalone or system [IRAS] compatible
- Wall mountable or free standing
- Model number family L208
- Input Power: 110 VAC
- Dimensions: 5.98" L x 3.13" W x 2.14" H
- ETL listed
- FCC Part 15B Compliant